Multiprinter 3

The Multiprinter 3 and the Multiprinter 3U are among the fastest and best printers at the point of sale. One of their distinguishing features is that several interfaces are integrated. This makes them particularly flexible during conversion and replacement. In addition to USB, serial and network RJ 45, an optional WLAN module is also available for special requirements.

The Multiprinter 3 is specially protected against the penetration of liquids from above. The power supply unit can be stored in a compartment directly in the printer so that the workstation is relieved of this load. The Multiprinter 3U is suitable for the substructure. This new concept saves space at the point of sale or, for example, at the kitchen pass. The USB connection is made via a USB cable with USB type A plugs on both sides. A USB cable TYPE A-Type A is included.

To use the printer with Hypersoft POS, a printer-specific USB driver must be installed on the device (POS). If the driver is not installed, the Hypersoft POS cashier mode will indicate a fault (printer icon flashes crossed out).

The required printer driver is provided or installed by Hypersoft and its resellers.

The receipt roll is inserted upside down:

Multi-printer 3 in WLAN

Special settings and limitations apply to the multi-printer 3 in the WLAN. See here ONLY use 2.4 GHZ....

Further documentation: Technical WLAN requirements of the devices

Back to the parent page: POS Printer