Set up weather data

When you start the MCP for the first time, you will be asked to determine the location for which you want to receive the weather data. This setting is globally valid for this client. Later the settings can be edited via the MCP settings.

The data has been transferred to your system since the beginning of the year. After setting, it may take a few minutes for this process to complete.

Activate weather data

  1. Select the program Weather settings from the program group Administration.
  2. Germany is set, Switzerland and Austria are available for selection. Enter the desired city or postcode under City name or Postcode search and select the city from the results list below.
  3. Confirm the location with the button Take over location and activate the button Subscribeto weather data free of charge . With Show, you can jump to the selected location on the map for checking.
  4. Press Exit - done. In the future, the weather data will be available in the Hypersoft Suite.
  5. Then, under Location/City, select the location whose weather data you want to use. We have no influence on the scope of the selection, as these are the weather stations connected to this service. Normally, however, you will find a representative entry.
  6. Press the tick Weatherdisplay .
  7. Restart the MCP (if necessary, there will be another waiting time of up to one minute at the first start). The weather is from now on always displayed in the MCP in the lower window area.

Further documentation: Use weather data

Back to the parent page: Settings of the MCP